CLI Usage
Basic System Configuration Guide 161
Last commit state : revert-failed
Last commit time : 10/23/2012 17:21:47
Checkpoint created with last commit : yes
Scheduled revert time : N/A
Last commit revert time : 10/23/2012 17:22:47
===============================================================================
Users in edit-cfg mode
===============================================================================
Username Type (from)
===============================================================================
admin Console
Joris Telnet (172.31.117.239)
===============================================================================
Rollback Commands
compare
Syntax compare [to source2]
compare source1 to source2
Context admin
admin>rollback
config>xx (where xx is any sub-branch at any level below config, but not at the config context
itself)
Description This command displays the differences between rollback checkpoints and the active operational
configuration, with source1 as the base/first file to which source2 is compared.
A compare operation does not check authorization of each line of output. Permission to execute the
compare operation from the admin branch of CLI (authorization for the admin rollback compare or
admin compare command itself) should only be given to users who are allowed to view the entire
configuration, similar to permissions for admin display-config.
Default The defaults for source1 and source2 are context aware and differ based on the branch in which the
command is executed. In general, the default for source1 matches the context from which the
command is issued.
• In the admin node: No defaults. source1 and source2 must be specified.
• In the admin>rollback node:
source1 default = active-cfg, source2 default = lastest-rb
compare: Equivalent to “compare active-cfg to lastest-rb”
compare to source2:Equivalent to “compare active-cfg to source2”
• In a config>xx node:
compare to source2: Equivalent to “compare active-cfg to source2”
To Next Page
Loading...
