CLI Usage
Basic System Configuration Guide 85
Context monitor
Description Displays monitor command output of traffic statistics for Cross Connect Aggregation Groups
(CCAGs) ports.
Parameters ccag-id — Specifies the CCAG instance to monitor.
path — Specifies the CCA path nodal context where the CCA path bandwidth, buffer and
accounting parameters are maintained. The path context must be specified with either the a
or b keyword specifying the CCA path context to be entered.
type — Specifies cross connect type.
Values sap-sap, sap-net, net-sap
interval — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
cpm-filter
Syntax cpm-filter
Context monitor
Description Displays monitor command output for CPM filters.
ip
Syntax ip entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>cpm-filter
Description This command displays monitor command statistics for IP filter entries.
Parameters entry entry-id — Displays information on the specified filter entry ID for the specified filter ID
only.
Values 1 to 65535
To Next Page
Loading...
