Basic CLI Command Reference
86 Basic System Configuration Guide
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
ipv6
Syntax ip entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>cpm-filter
Description This command displays monitor command statistics for IPv6 filter entries and is supported on the
7750 SR and 7950 XRS.
Parameters entry entry-id — Displays information on the specified filter entry ID for the specified filter ID
only.
Values 1 to 65535
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
mac
Syntax mac entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>cpm-filter
To Next Page
Loading...
