System Management
Basic System Configuration Guide 435
config — Synchronize only the primary, secondary, and tertiary configuration files.
Default config
Peer Commands
peer
Syntax [no] peer ip-address
Context config>redundancy>multi-chassis
Description This command configures a multi-chassis redundancy peer.
Parameters ip-address — Specifies a peer IP address. Multicast address are not allowed.
authentication-key
Syntax authentication-key [authentication-key | hash-key] [hash | hash2]
no authentication-key
Context config>redundancy>multi-chassis>peer
Description This command configures the authentication key used between this node and the multi-chassis peer.
The authentication key can be any combination of letters or numbers.
Parameters authentication-key — Specifies the authentication key. Allowed values are any string up to 20
characters long composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
hash-key — The hash key. The key can be any combination of ASCII characters up to 33 (hash1-
key) or 55 (hash2-key) characters in length (encrypted). If spaces are used in the string,
enclose the entire string in quotation marks (“ ”).
hash — Specifies the key is entered in an encrypted form. If the hash or hash2 parameter is not
used, the key is assumed to be in an unencrypted, clear text form. For security, all keys are
stored in encrypted form in the configuration file with the hash or hash2 parameter specified
hash2 — Specifies the key is entered in a more complex encrypted form that involves more
variables than the key value alone, meaning that the hash2 encrypted variable cannot be
copied and pasted. If the hash or hash2 parameter is not used, the key is assumed to be in an
unencrypted, clear text form. For security, all keys are stored in encrypted form in the
configuration file with the hash or hash2 parameter specified.
To Next Page
Loading...
