System Command Reference
350 Basic System Configuration Guide
switchover-exec
Syntax switchover-exec file-url
no switchover-exec
Context config>system
Description This command specifies the location and name of the CLI script file executed following a redundancy
switchover from the previously active CPM card. A switchover can happen because of a fatal failure
or by manual action.
The CLI script file can contain commands for environment settings, debug (excluding mirroring
settings), and other commands not maintained by the configuration redundancy.
The following commands are not supported in the switchover-exec file: clear, configure, candidate,
oam, tools, oam, ping, traceroute, mstat, mtrace and mrinfo.
When the file-url parameter is not specified, no CLI script file is executed.
Default none
Parameters file-url — Specifies the location and name of the CLI script file.
port
Syntax port port-id to port-id [create]
no port port-id
Context config>system>port-topology
Description This command configures the binding between a host port ID and the satellite uplink from the satellite
chassis. The port-topology can be configured with the host connected to a satellite uplink or the
satellite uplink port connected to the specified host port. Both configurations are supported, as shown
in the following usage examples:
*A:Dut-A# configure system port-topology port esat-1/1/u4 to 1/2/2 create
*A:Dut-A# configure system port-topology no port esat-1/1/u4
*A:Dut-A# configure system port-topology port 1/2/2 to esat-1/1/u4 create
*A:Dut-A# configure system port-topology no port 1/2/2
Parameters port-id — Specifies the host connected to a satellite uplink in the format slot/mda/port, or the
satellite uplink port connected to the specified host port in the format sat-id/1/u<port-#>.
Values
port-id slot/mda/port
eth-sat-id esat-id/slot/[u]port
esat keyword
id [1..20]
u keyword for up-link port
To Next Page
Loading...
