System Management
Basic System Configuration Guide 351
create — The keyword required to create the binding between a host port ID and the satellite
uplink.
satellite
Syntax satellite
Context config>system
Description This command is used to enter the satellite configuration context. Within the satellite context, the
administrator can specify the configuration details for a satellite chassis that is hosted by the associated
local system.
Default none
description
Syntax description description-string
no description
Context config>system>satellite>eth-sat
Description This command defines a description string that is tied to the associated Ethernet satellite.
The no form of the command deletes the associated description string.
Default no description
Parameters description-string — Ethernet satellite description up to 80 characters in length.
eth-sat
Syntax [no] eth-sat sat-id [create]
Context config>system>satellite
Description This command creates the specified Ethernet satellite configuration context. Specific parameters
including software-repository, satellite-type, satellite MAC address and sync-e can be configured or
modified within this context.
The no form of the command deletes the specified Ethernet satellite.
Default none
Parameters sat-id — Specifies the satellite ID for the associated Ethernet satellite.
Values 1 to 20
To Next Page
Loading...
