System Command Reference
352 Basic System Configuration Guide
create — The keyword required to create a new Ethernet satellite context.
mac-address
Syntax mac-address mac-address
no mac-address
Context config>system>satellite>eth-sat
Description This command configures the MAC address for the associated Ethernet satellite chassis. This MAC
address is used to validate the identity of an Ethernet satellite that attempts to associate with the local
host.
The no form of the command deletes the MAC address for the associated Ethernet satellite.
Default none
Parameters mac-address — Specifies the MAC address of the associated Ethernet satellite chassis; the MAC
should not be a broadcast or multicast MAC. The MAC address should be entered in either
of the following formats: xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx.
sat-type
Syntax sat-type sat-type
no sat-type
Context config>system>satellite>eth-sat
Description This command configures the type of Ethernet satellite variant for the associated satellite chassis.
The no form of the command deletes the sat-type configuration.
Default no sat-type
Parameters sat-type — Specifies the Ethernet satellite type. Configuration of the following variants is
supported:
es24-1gb-sfp — Specifies the 24xGE (SFP) + 4x10GE satellite.
es48-1gb-sfp — Specifies the 48xGE (SFP) + 4x10GE satellite.
shutdown
Syntax [no] shutdown
Context config>system>satellite>eth-sat
Description This command disables the associated Ethernet satellite.
To Next Page
Loading...
