System Command Reference
410 Basic System Configuration Guide
ssh — Disconnects the SSH session.
netconf — Disconnects the NETCONF session.
display-config
Syntax display-config [detail | index]
Context admin
Description This command displays the system’s running configuration.
By default, only non-default settings are displayed.
Specifying the detail option displays all default and non-default configuration parameters.
Parameters detail — Displays default and non-default configuration parameters.
index — Displays only persistent-indices.
reboot
Syntax reboot [active | standby | upgrade] [hold] [now]
Context admin
Description This command reboots the router or one CPM and can also be used to force an upgrade of the system
boot ROMs.
If no options are specified, the user is prompted to confirm the reboot operation. Answering yes (y)
will result in both CPMs and all IOMs rebooting.
ALA-1>admin# reboot
Are you sure you want to reboot (y/n)?
Parameters active — Keyword to reboot the active CPM.
Default active
standby — Keyword to reboot the standby CPM.
Default active
upgrade — Forces card firmware to be upgraded during chassis reboot. Normally, the SR-series
router OS automatically performs firmware upgrades on CPMs and XCM/IOM cards without
the need for the upgrade keyword. The automatic upgrade must be enabled in the SR OS7
Command Line Interface (CLI) when rebooting the system.
When the upgrade keyword is specified, a chassis flag is set for the BOOT Loader (boot.ldr)
and on the subsequent boot of the OS on the chassis, firmware images on CPMs, XCMs, or
IOMs will be upgraded automatically.
To Next Page
Loading...
