System Management
Basic System Configuration Guide 409
disconnect
Syntax disconnect [address ip-address | username user-name | console | telnet | ftp | ssh |
netconf]
Context admin
Description This command disconnects a user from a session.
Disconnect without any parameters will disconnect the session in which the command was executed.
If any of the session type options (for example, console, telnet, FTP, SSH) are specified, then only the
respective sessions are affected.
If no session type options are specified, then all sessions from the IP address or from the specified user
are disconnected.
Any task that the user is executing is terminated. FTP files accessed by the user will not be removed.
A major severity security log event is created specifying what was terminated and by whom.
Default none — No disconnect options are configured.
Parameters address ip-address — The IP address to disconnect, specified in dotted decimal notation.
Values
username user-name — The name of the user.
console — Disconnects the console session.
telnet — Disconnects the Telnet session.
ftp — Disconnects the FTP session.
interface - 32 chars max, for link local addresses 255
cflash-id cf1:|cf1-A:|cf1-B:|cf2:|cf2-A:|cf2-B:|cf3:|cf3-A:|cf3-B:
Note: Ipv6 is supported on the 7750 SR and 7950 XRS.
ipv4-address a.b.c.d
ipv6-address x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x - [0..FFFF]H
d - [0..255]D
To Next Page
Loading...
