CLI Usage
Basic System Configuration Guide 131
Parameters ospf-instance — Specifies the OSPF instance.
Values 1 to 31
ospf3
Syntax ospf3
Context monitor>router
Description This command enables the context to configure monitor commands for the OSPF3 instance and applies
to the 7750 SR or 7950 XRS.
interface
Syntax interface interface [interface...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |
rate]
Context monitor>router>ospf
monitor>router>ospf3
Description This command displays statistics for OSPF interfaces at the configured interval until the configured
count is reached.
The first screen displays the current statistics related to the OSPF interface(s). The subsequent
statistical information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the rate-per-second for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters interface — Specify IP address of the interface (ip-address) or interface name (ip-int-name). Up
to 5 interfaces can be specified. If the string contains special characters (#, $, spaces, etc.), the
entire string must be enclosed within double quotes.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
To Next Page
Loading...
