CLI Usage
Basic System Configuration Guide 145
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the absolute rate-per-second value for each
statistic is displayed.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
Output
Sample Output
*A:cses-A13# monitor service id 88 sap 1/1/2:0
===============================================================================
Monitor statistics for Service 88 SAP 1/1/2:0
===============================================================================
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
SONET/
SDH
IPCP — The SAP is identified by the channel.
No BCP is deployed and all traffic is
IP.
SONET/
SDH
TDM
BCP-Null 0 The SAP is identified with a single
service on the channel. Tags are
assumed to be part of the customer
packet and not a service delimiter.
SONET/
SDH
TDM
BCP-Dot1q 0 to 4094 The SAP is identified by the 802.1Q
tag on the channel.
SONET/
SDH
TDM
Frame Relay 16 to 991 The SAP is identified by the data link
connection identifier (DLCI).
SONET/
SDH
ATM
ATM vpi (NNI) 0 to 4095
vpi (UNI) 0 to 255
vci 1, 2, 5 to 65535
The SAP is identified by port or by
PVPC or PVCC identifier (vpi, vpi/
vci, or vpi range)
Table 21: qtag values by port and encapsulation type (Continued)
Port Type Encap-Type Allowed Values Comments
To Next Page
Loading...
