Basic CLI Command Reference
148 Basic System Configuration Guide
instance
Syntax instance interface interface-name vr-id virtual-router-id [interval seconds] [repeat repeat]
[absolute | rate]
Context monitor>router>vrrp
Description Monitor statistics for a VRRP instance.
Parameters interface-name — The name of the existing IP interface on which VRRP is configured.
vr-id virtual-router-id — The virtual router ID for the existing IP interface, expressed as a
decimal integer.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
subscriber
Syntax subscriber sub-ident-string sap sap-id sla-profile sla-profile-name [base | ingress-queue-
id ingress-queue-id | egress-queue-id egress-queue-id] [interval seconds] [repeat repeat]
[absolute | rate]
Context monitor>service
Description This command monitors statistics for a subscriber.
Parameters sub-ident-string — Specifies an existing subscriber identification profile to monitor.
sap sap-id — Specifies the physical port identifier portion of the SAP definition.
Values dlci 16 to 1022
sla-profile sla-profile-name — Specifies an existing SLA profile.
interval seconds — Configures the interval for each display in seconds
Default 11
Values 11 to 60
To Next Page
Loading...
