BOF Configuration Command Reference
220 Basic System Configuration Guide
When autonegotiation is enabled, the link attempts to automatically negotiate the link speed and
duplex parameters. If autonegotiation is enabled, then the configured duplex and speed parameters are
ignored.
The no form of the command disables the autonegotiate feature on this port.
Parameters limited — Specifies ethernet ports to be configurable to use link autonegotiation but with only a
single speed/duplex combination advertised. This allows a specific speed/duplex to be
guaranteed without having to turn off autonegotiation, which is not allowed for 1000BASE-T.
duplex
Syntax duplex {full | half}
Context bof
Description This command configures the duplex mode of the CPM management Ethernet port when
autonegotiation is disabled in the running configuration and the Boot Option File (BOF). If the port is
configured to autonegotiate this parameter will be ignored.
Default duplex full — Full duplex operation.
Parameters full — Sets the link to full duplex mode.
half — Sets the link to half duplex mode.
fips-140-2
Syntax [no] fips-140-2
Context bof
Description This command is used to configure the node in FIPS-140-2 mode. Before using this command, the
operator much ensure that no current configuration exists in the config file that is not supported in
FIPS-140-2 mode. Failing to remove unsupported configuration will result in the node being unable to
boot up. The node must be rebooted after executing this command in order for the node to begin
operating in FIPS-140-2 mode.
Default no fips-140-2
li-local-save
Syntax [no] li-local-save
Context bof
Description This command enables the lawful intercept (LI) configuration to be saved locally.
To Next Page
Loading...
