Common Configuration Tasks
302 Basic System Configuration Guide
multicastclient
no shutdown
----------------------------------------------
A:ALA-12>config>system>time##
NTP-Server
The ntp-server command configures the node to assume the role of an NTP server. Unless
the server command is used this node will function as an NTP client only and will not
distribute the time to downstream network elements. If authentication is specified in this
command, the NTP server requires client packets to be authenticated based on the key
received in the client request.
CLI Syntax: config>system>time>ntp
ntp-server [authenticate]
Example: config>system>time>ntp#
config>system>time>ntp# ntp-server
config>system>time>ntp# no shutdown
The following example shows NTP enabled with the ntp-server command configured.
A:sim1>config>system>time>ntp# info
----------------------------------------------
no shutdown
ntp-server
----------------------------------------------
A:sim1>config>system>time>ntp#
Peer
Configuration of an NTP peer configures symmetric active mode for the configured peer.
Although any system can be configured to peer with any other NTP node, it is recommended
to configure authentication and to configure known time servers as their peers. Use the no
form of the command to remove the configured peer.
CLI Syntax: config>system>time>ntp
peer ip-address [version version] [key-id key-
id]
[prefer]
Example: config>system>time>ntp#
config>system>time>ntp# peer 192.168.1.1 key-id 1
config>system>time>ntp# no shutdown
To Next Page
Loading...
