Common Configuration Tasks
304 Basic System Configuration Guide
time
sntp
broadcast-client
server-address ip-address [version version-
number] [normal|preferred] [interval
seconds]
no shutdown
Broadcast-client
The broadcast-client command enables listening at the global device level to SNTP
broadcast messages on interfaces with broadcast client enabled.
CLI Syntax: config>system>time>sntp
broadcast-client
Example: config>system>time>sntp#
config>system>time>sntp# broadcast-client
config>system>time>sntp# no shutdown
The following example shows SNTP enabled with the broadcast-client command enabled.
A:ALA-12>config>system>time# info
----------------------------------------------
sntp
broadcast-client
no shutdown
exit
dst-zone PT
start second sunday april 02:00
end first sunday october 02:00
offset 0
exit
zone GMT
----------------------------------------------
A:ALA-12>config>system>time#
Server-address
The server-address command configures an SNTP server for SNTP unicast client mode.
CLI Syntax: config>system>time>sntp#
config>system>time>sntp# server-address ip-address
version version-number] [normal|preferred] [interval
seconds]
Example: config>system>time>sntp#
To Next Page
Loading...
