System Management
Basic System Configuration Guide 361
If a rising-event rmon-event-id is configured, the CLI requires a rising-threshold to also be
configured.
Default 0
Values 0 to 65535
rising-threshold threshold — Specifies a threshold for the sampled statistic. When the current
sampled value is greater than or equal to this threshold, and the value at the last sampling
interval was less than this threshold, a single threshold crossing event will be generated. A
single threshold crossing event will also be generated if the first sample taken is greater than
or equal to this threshold and the associated startup-alarm is equal to rising or either.
After a rising threshold crossing event is generated, another such event will not be generated
until the sampled value falls below this threshold and reaches less than or equal the falling-
threshold value.
Default 0
Values -2147483648 to 2147483647
falling-event rmon-event-id — The identifier of the rmon>event that specifies the action to be
taken when a falling threshold crossing event occurs. If there is no corresponding event
configured for the specified rmon-event-id, then no association exists and no action is taken.
If the falling-event has a value of zero (0), no associated event exists.
If a falling-event is configured, the CLI requires a falling-threshold to also be configured.
Default 0
Values 0 to 65535
falling-threshold threshold — Specifies a threshold for the sampled statistic. When the current
sampled value is less than or equal to this threshold, and the value at the last sampling interval
was greater than this threshold, a single threshold crossing event will be generated. A single
threshold crossing event will also be generated if the first sample taken is less than or equal
to this threshold and the associated startup-alarm is equal to falling or either.
After a falling threshold crossing event is generated, another such event will not be generated
until the sampled value rises above this threshold and reaches greater than or equal the rising-
threshold value.
Default 0
Values -2147483648 to 2147483647
owner owner — The owner identifies the creator of this alarm. It defaults to "TiMOS CLI". This
parameter is defined primarily to allow entries that have been created in the RMON-MIB
alarmTable by remote SNMP managers to be saved and reloaded in a CLI configuration file.
The owner will not normally be configured by CLI users and can be a maximum of 80
characters long.
Default TiMOS CLI
Configuration example
alarm 3 variable-oid ifInOctets.184582144 interval 20 sample-type delta
To Next Page
Loading...
