System Command Reference
420 Basic System Configuration Guide
anno-rx-timeout
Syntax anno-rx-timeout count
no anno-rx-timeout
Context config>system>ptp
Description This command configures the announceReceiptTimeout value for all peer associations. This defines
the number of Announce message intervals that must expire with no received Announce messages
before declaring an ANNOUNCE_RECIPT_TIMEOUT event.
The announce-rx-timeout cannot be changed unless PTP is shut down.
Default 3
Parameters count — The announce packet interval, in log form.
Values 2to 10
clock-type
Syntax clock-type boundary
clock-type ordinary {master | slave}
Context config>system>ptp
Description This command configures the type of clock. The clock-type can only be changed when PTP is
shutdown.
The clock-type cannot be changed to ordinary master if the PTP reference is no shutdown. In addition,
the clock-type cannot be changed to ordinary master if there are peers configured. The clock-type is
restricted based on the profile. See the profile command description for the details of the restrictions.
Default ordinary slave
Parameters boundary — The system is a boundary clock, which may be anywhere in the master-slave clock
hierarchy. It can obtain timing from a master clock, and provide timing to multiple slave
clocks concurrently.
ordinary master — The system is a grandmaster clock in the master-slave hierarchy. The system
provides timing to multiple slave clocks in the network.
ordinary slave — The system is always a slave clock in the master-slave hierarchy. The system
derives its timing from one or more master clocks in the network.
domain
Syntax domain domain
no domain
To Next Page
Loading...
