System Command Reference
422 Basic System Configuration Guide
1 (1 packet every 2 seconds) for g8265dot1-2010 or
-3 (8 packets per second) for g8275dot1-2014
Parameters log-interval — The announce packet interval, in log form.
Values -3 - 4
network-type
Syntax network-type {sdh | sonet}
Context config>system>ptp
Description This command configures the codeset to be used for the encoding of QL values into PTP clockClass
values when the profile is configured for G.8265.1. The codeset is defined in Table 1/G.8265.1. This
setting only applies to the range of values observed in the clockClass values transmitted out of the node
in Announce messages. The router will support the reception of any valid value in Table 1/G.8265.1
Default sdh
Parameters sdh — Specifies the values used on a G.781 Option 1 compliant network.
sonet — Specifies the values used on a G.781 Option 2 compliant network
priority1
Syntax priority1 priority
no priority1
Context config>system>ptp
Description This command configures the priority1 value of the local clock. This parameter is only used when the
profile is set to ieee1588-2008. This value is used by the Best Master Clock Algorithm to determine
which clock should provide timing for the network.
This value is used for the value to advertise in the Announce messages and for the local clock value in
data set comparisons.
The no form of the command reverts to the default configuration.
Default 128
Parameters priority — Specifies the value of the priority1 field.
Values 0 to 255
To Next Page
Loading...
