System Command Reference
424 Basic System Configuration Guide
If the parameter is set to a value other than the default for the original profile, then its value will remain
unchanged
Default g8265dot1-2010
Parameters g8265dot1-2010 — Conform to the ITU-T G.8265.1 specification.
ieee1588-2008 — Conform to the 2008 version of the IEEE1588 standard.
g8275dot1-2014 — Conform to the ITU-T G.8275.1 specification.
peer-limit
Syntax peer-limit limit
no peer-limit
Context configure>system>ptp
Description This command specifies an upper limit to the number of discovered peers permitted within the routing
instance. This can be used to ensure that a routing instance does not consume all the possible
discovered peers and blocking discovered peers in other routing instances.
If it is desired to reserve a fixed number of discovered peers per router instance, then all router
instances supporting PTP should have values specified with this command and the sum of all the peer-
limit values must not exceed the maximum number of discovered peers supported by the system.
If the user attempts to specify a peer-limit, and there are already more discovered peers in the routing
instance than the new limit being specified, the configuration will not be accepted.
Default no limit
Parameters limit — Specifies the maximum number of discovered peers allowed in the routing instance.
Values 0 to 50
Default 1 (The maximum number of discovered peers supported by the
system.)
peer
Syntax peer ip-address [create]
no peer ip-address
Context config>system>ptp
Description This command configures a remote PTP peer. It provides the context to configure parameters for the
remote PTP peer.
Up to 20 remote PTP peers may be configured.
The no form of the command deletes the specified peer.
To Next Page
Loading...
