System Command Reference
442 Basic System Configuration Guide
The no form of this command sets the interval to default value
Default 5 (0.5s)
Parameters interval — The time interval expressed in deciseconds
Values 5 to 500 (tenths of a second)
passive-mode
Syntax [no] passive-mode
Context config>redundancy>multi-chassis>peer>mc-ep
Description This command configures the passive mode behavior for the MC-EP protocol. When in passive mode
the MC-EP pair will be dormant until two of the pseudowires in a MC-EP will be signaled as active by
the remote PEs, being assumed that the remote pair is configured with regular MC-EP. As soon as more
than one pseudowire is active, dormant MC-EP pair will activate. It will use the regular exchange to
select the best pseudowire between the active ones and it will block the Rx and Tx directions of the
other pseudowires.
The no form of this command will disable the passive mode behavior.
Default no passive-mode
system-priority
Syntax system-priority value
no system-priority
Context config>redundancy>multi-chassis>peer>mc-ep
Description This command allows the operator to set the system priority. The peer configured with the lowest value
is chosen to be the master. If system-priority are equal then the one with the highest system-id (chassis
MAC address) is chosen as the master.
The no form of this command sets the system priority to default.
MC-LAG Commands
mc-lag
Syntax [no] mc-lag
Context config>redundancy>multi-chassis>peer>mc-lag
To Next Page
Loading...
