System Management
Basic System Configuration Guide 453
disabled — Specifies that the LLDP agent will not transmit or receive LLDP frames on this port.
If there is remote systems information which is received on this port and stored in other tables,
before the port's admin status becomes disabled, then the information will naturally age out.
notification
Syntax [no] notification
Context config>port>ethernet>lldp>dstmac
Description This command enables LLDP notifications.
The no form of the command disables LLDP notifications.
tx-mgmt-address
Syntax tx-mgmt-address [system]
no tx-mgmt-address
Context config>port>ethernet>lldp>dstmac
Description This command specifies which management address to transmit.
The no form of the command resets value to the default.
Default no tx-mgmt-address
Parameters system — Specifies to use the system IP address. The system address will only be transmitted
once it has been configured if this parameter is specified
tx-tlvs
Syntax tx-tlvs [port-desc] [sys-name] [sys-desc] [sys-cap]
no tx-tlvs
Context config>port>ethernet>lldp>dstmac
Description This command specifies which LLDP TLVs to transmit.
The no form of the command resets the value to the default.
Default no tx-tlvs
Parameters port-desc — Indicates that the LLDP agent should transmit port description TLVs.
sys-name — Indicates that the LLDP agent should transmit system name TLVs.
sys-desc — Indicates that the LLDP agent should transmit system description TLVs.
To Next Page
Loading...
