Show, Clear, Debug, and Tools Command Reference
478 Basic System Configuration Guide
Table 50: Show NTP Field Description
Label Description
Enabled yes — NTP is enabled.
no — NTP is disabled.
Admin Status yes — Administrative state is enabled.
no — Administrative state is disabled.
NTP Server Displays NTP server state of this node.
Stratum Displays stratum level of this node.
Oper Status yes — The operational state is enabled.
no — The operational state is disabled.
Auth Check Displays the authentication requirement
System Ref. ID IP address of this node or a 4-character ASCII code showing the state.
Auth Error Displays the number of authentication errors.
Auth Errors Ignored Displays the number of authentication errors ignored.
Auth key ID Errors Displays the number of key identification errors.
Auth Key Type Errors Displays the number of authentication key type errors.
Reject The peer is rejected and will not be used for synchronization. Rejection
reasons could be the peer is unreachable, the peer is synchronized to this
local server so synchronizing with it would create a sync loop, or the
synchronization distance is too large. This is the normal startup state.
Invalid The peer is not maintaining an accurate clock. This peer will not be used
for synchronization.
Excess The peer's synchronization distance is greater than ten other peers. This
peer will not be used for synchronization.
Outlier The peer is discarded as an outlier. This peer will not be used for
synchronization.
Candidate The peer is accepted as a possible source of synchronization.
Selected The peer is an acceptable source of synchronization, but its
synchronization distance is greater than six other peers.
Chosen The peer is chosen as the source of synchronization.
ChosenPPS The peer is chosen as the source of synchronization, but the actual
synchronization is occurring from a pulse-per-second (PPS) signal.
To Next Page
Loading...
