Show, Clear, Debug, and Tools Command Reference
528 Basic System Configuration Guide
Sample Output
The following system example shows:
• sync-if timing, or
Not Qualified Due To Indicates the reason why the reference has not been qualified:
• disabled
•LOS
•OOPIR
•OOF
Selected for Use Indicates whether the method is presently selected.
Not Selected Due To Indicates the reason why the method is not selected:
• disabled
• not qualified
• previous failure
•LOF
• AIS-L
• validating
• on standby
• ssm quality
Source Port Identifies the Source port for the reference.
Interface Type The interface type configured for the BITS port.
Framing The framing configured for the BITS port.
Line Coding The line coding configured for the BITS port.
Line Length The line length value of the BITS output.
Output Admin Status down — The BITS output is administratively shutdown.
up — The BITS output is administratively enabled.
Output Source The source to be used to provide the signal on the BITS output port.
line reference — unfiltered recovered line reference.
internal clock — filtered node clock output.
Output Reference
Selected
The reference selected as the source for the BITS output signal (ref1, ref2,
or PTP).
TX Quality Level QL value for BITS output signal.
Table 70: System Timing Output (Continued)
Label Description (Continued)
To Next Page
Loading...
