Show, Clear, Debug, and Tools Command Reference
534 Basic System Configuration Guide
Output Admin Status : up
Output Source : line reference
Output Reference Selected : ref1
Tx Quality Level : prc
===============================================================================
synchronization
Syntax synchronization
Context show>redundancy>synchronization
Description This command displays redundancy synchronization times.
Output The following table describes redundancy synchronization output fields.
Sample Output
A:ALA-1>show>redundancy# synchronization
===============================================================================
Table 71: Synchronization Output
Label Description
Standby Status Displays the status of the standby CPM.
Last Standby Failure Displays the timestamp of the last standby failure.
Standby Up Time Displays the length of time the standby CPM has been up.
Failover Time Displays the timestamp when the last redundancy failover occurred
causing a switchover from active to standby CPM. If there is no redundant
CPM card in this system or no failover has occurred since the system last
booted, the value will be 0.
Failover Reason Displays a text string giving an explanation of the cause of the last
redundancy failover. If no failover has occurred, an empty string displays.
Boot/Config Sync
Mode
Displays the type of synchronization operation to perform between the
primary and secondary CPMs after a change has been made to the
configuration files or the boot environment information contained in the
boot options file (BOF).
Boot/Config Sync
Status
Displays the results of the last synchronization operation between the
primary and secondary CPMs.
Last Config File Sync
Time
Displays the timestamp of the last successful synchronization of the
configuration files.
Last Boot Env Sync
Time
Displays the timestamp of the last successful synchronization of the boot
environment files.
To Next Page
Loading...
