System Management
Basic System Configuration Guide 545
The test is already in-progress in another session
Other notes (which are also relayed to the operator when the test is attempted):
• All provisioned XCMs will be reset at the start of the test and will be held in the booting state
until the test has completed.
• All SFMs will be cleared when the operator exits the test. This will trigger a reset of the
XCMs and the standby CPM.
Output
Sample Output
*A:Dut-A# tools perform system inter-chassis sfm-interco-test
WARNING: This test is intended for an out-of-service standalone chassis that is
going to later become the extension chassis of an XRS-40 system.
At the start of the test, all provisioned IOMs will be reset and will be held
in the 'booting' state until the test has completed.
While the test is running avoid altering this system or the attached system
(e.g. do not shutdown, clear, or remove the CPMs/SFMs/IOMs and do not issue
CPM switchovers)
Once testing has completed all SFMs in this system will be cleared.
Do you wish to proceed (y/n)? y
Clearing provisioned IOMs ...
Test executing ...
Displaying results
===============================================================================
SFM Interconnect Port Summary
===============================================================================
SFM SFM IcPort IcPort Module Degrade Miscon Info
Oper State Num Oper State Inserted State SFM IcPort
-------------------------------------------------------------------------------
1 up 1 up yes none
1 up 2 up yes none
1 up 3 up yes none
1 up 4 up yes none
1 up 5 up yes none
1 up 6 up yes none
1 up 7 up yes none
1 up 8 up yes none
1 up 9 up yes none
1 up 10 up yes none
1 up 11 up yes none
1 up 12 up yes none
1 up 13 up yes none
1 up 14 up yes none
2 up 1 up yes none
2 up 2 up yes none
2 up 3 up yes none
2 up 4 up yes none
To Next Page
Loading...
