Alcatel-Lucent 7450 - Page 204

Command Hierarchies
Page 204 7450 ESS MPLS Guide
—mpls
— bypass-tunnel
— ftn
— ilm
— lspinfo
— memory-usage
— te-lspinfo [endpoint ip-address] [sender ip-address] [lspid lsp-id] [detail]
[p2p | p2p-tid tunnel-id]
— te-lspinfo [endpoint ip-address] [sender ip-address] [lspid lsp-id] [detail]
[p2p | p2p-tid tunnel-id]{ [phops] [nhops] [s2l ip-address] } }
—rsvp
— psb
— rsb
— perform
— router
—mpls
— adjust-autobandwidth [lsp lsp-name [force [bandwidth mbps]]]
— cspf to ip-address
— force-switch-path [lsp lsp-name] [path path-name
]
— [no] force-switch-path [lsp lsp-name]
— plr to ip-addr [from ip-addr] [bandwidth bandwidth] [include-bitmap
bitmap] [exclude-bitmap bitmap] [hop-limit limit] [exclude-address
excl-addr [excl-addr...(up to 8 max)]] [use-te-metric] [strict-srlg] [srlg-
group grp-id...(up to 8 max)] [exclude-node excl-node-id [excl-node-
id..(up to 8 max)]] [skip-interface interface-name] [ds-class-type class-
type] [cspf-reqtype req-type] [least-fill-min-thd thd] [setup-priority val]
[hold-priority val]
— resignal {lsp lsp-name path path-name | delay minutes}
— resignal {p2mp-lsp p2mp-lsp-name
p2mp-instance p2mp-instance-name
| p2mp-delay p2mp-minutes}
— resignal-bypass {lsp bypass-lsp-name [force] | delay minutes}
— revert [lsp lsp-name]
— switch-path [lsp lsp-name] [path path-name]
— trap-suppress number-of-traps time-interval
— update-path {lsp lsp-name path current-path-name new-path new-path-
name}