GMPLS
7450 ESS MPLS Guide Page 493
Sample Output
A:ALA-1# show router lmp peer 16843009 control-channel 1
================================================================================
LMP Control Channel 1 Statistics
================================================================================
Admin State: : Out of Service Oper State : Going Down
Remote Id : 10 Setup Role : Active
Hello Interval : 3000 Hello Dead Intv : 10000
Peer If Addr : 100.100.100.100
Inbound Errors : 100 Outbound Errors : 50
--------------------------------------------------------------------------------
Message Type Received Sent Retransmitted
--------------------------------------------------------------------------------
Config 1111 11 111
ConfigAck 15 6 N/A
ConfigNack 1 2 N/A
Hello 40 20 N/A
LinkSummary 6000 500 10
LinkSummaryAck 35 30 N/A
LinkSummaryNack 400 3000 N/A
================================================================================
A:ALA-1#
te-link
Syntax te-link [te-link-id] [detail]
te-link te-link-id statistics
Context show>router>lmp
Description This command displays Traffic Engineering (TE) link information.
Parameters te-link-id — Specifies the ID of a TE Link.
Values 1 — 4294967295 | te-link-name
te-link-name: 32 character (max) name of the TE Link
detail — Keyword to display more detailed output.
statistics — Keyword to display TE Link statistics.
Output TE Link Output Fields — The following table describes TE link output fields.
Received
The total number of received packets of a specific type.
Sent
The total number of sent packets of a specific type.
Retransmitted
The total number of retransmitted packets of a specific type.
Label Description (Continued)
Label Description
Admin State
The administrative state of the TE link.
To Next Page
Loading...
