Alcatel-Lucent 7450 - Page 639

LDP Commands
7450 ESS MPLS Guide Page 639
— [no] prefer-tunnel-in-tunnel
— session-parameters
— [no] peer ip-address
—[no] adv-adj-addr-only
— [no] dod-label-distribution
— export-addresses policy-name [policy-name...(up to 5 max)]
—no export-addresses
— export-prefixes policy-name [policy-name...(up to 5 max)]
— no export-prefixes
— fec-limit limit [log-only] [threshold percentage]
—no fec-limit
— [no] fec129-cisco-interop
— fec-type-capability
— p2mp {enable | disable}
— prefix-ipv4 {enable | disable}
— prefix-ipv6 {enable | disable}
— import-prefixes policy-name [policy-name...(up to 5 max)]
—no import-prefixes
— [no]
pe-id-mac-flush-interop
— [no] shortcut-transit-ttl-propagate
— [no] shortcut-local-ttl-propagate
— [no] shutdown
— targeted-session
— [no] disable-targeted-session
— export-prefixes policy-name [policy-name...(up to 5 max)]
—no export-prefixes
— import-prefixes policy-name [policy-name...(up to 5 max)]
—no import-prefixes
— ipv4
— hello timeout factor
—no hello
— hello-reduction {enable factor | disable}
—no hello-reduction
— keepalive timeout factor
—no keepalive
— ipv6
— hello timeout factor
—no hello
— hello-reduction {enable factor | disable}
—no hello-reduction
— keepalive timeout factor
—no keepalive
— peer ip-address
—no peer ip-address
— [no] bfd-enable
— hello timeout factor
—no hello
— hello-reduction {enable factor | disable}
—no hello-reduction
— keepalive timeout factor
—no keepalive
— local-lsr-id interface-name
—no local-lsr-id
— [no] shutdown
— [no] tunneling