Alcolizer le5 - Testing Types

REF: LE5 Alcohol Tester User Manual V16.docx Page 8 © Alcolizer Technology
Uncontrolled when printed
3.1.1 Cleaning requirements
 The instrument should be cleaned with a soft cloth and antibacterial spray or anti-
bacterial wipes. It is recommended that the instrument is turned off before
cleaning.
 The outside of the instrument can be cleaned by wiping it over with a soft moist cloth
followed by a soft dry cloth.
 Screen – the screen of the instrument can be cleaned by wiping it over with a soft
moist cloth followed by a soft dry cloth.
 Ensure the Spigot Inlet is not blocked.
 Do not use alcohol based cleaners.
 Do not use harsh cleaning agents, abrasive cleaning pads or chemicals.
 Rubber gloves should be used during cleaning of the instrument.
3.2 Testing Types
The LE5 can perform both Mouthpiece and Passive testing:
 Standard – Mouthpiece test

 Passive Standard – If alcohol is present, the instrument will require a
Mouthpiece test

 Passive Only – The instrument will not automatically require a Mouthpiece
test following an alcohol present passive test

Mouthpiece testing provides a BrAC reading in g/210L (or other measuring units as required).
Passive testing will display the presence of alcohol in breath. If a Passive test indicates the presence
of alcohol, a Mouthpiece test should be performed if an accurate BrAC is required.
NOTE
Mouthpiece testing is also referred to as Standard or Active Testing.