Allen-Bradley 1769 - Minimum System Requirements; Equipment Phase Instructions

118 Rockwell Automation Publication 1769-UM011H-EN-P - April 2012
Chapter 8 Configure PhaseManager
Minimum System
Requirements
To develop PhaseManager programs, you need:
• a CompactLogix controller with firmware revision 16.0 or later.
• a communication path to the controller.
• RSLogix 5000 programming software, version 15.0 or later.
To enable PhaseManager support, you need the full or professional editions of
RSLogix 5000 programming software or the optional PhaseManager add-on
(9324-RLDPMENE) to your RSLogix 5000 programming software package.
Equipment Phase
Instructions
With CompactLogix controllers, you can issue many ladder diagram (LD) and
structured text (ST) instructions to begin various equipment phases.
Instruction Code Instruction
PSC Signal a phase that the state routine is complete so go to the next state
PCMD Change the state or substate of a phase
PFL Signal a failure for a phase
PCLF Clear the failure code of a phase
PXRQ Initiate communication with RSBizWare Batch software
PRNP Clear the NewInputParameters bit of a phase
PPD Set up breakpoints within the logic of a phase
PATT Take ownership of a phase to either:
• prevent another program or RSBizWare Batch software from commanding a
phase
or
• make sure another program or RSBizWare Batch software does not already own
a phase
PDET Relinquish ownership of a phase
POVR Override a command