Rockwell Automation Publication 1769-UM011H-EN-P - April 2012 19
Install the 1769-L3x Controllers Chapter 2
Parts List
These components are shipped with the controller.
You may also use these components with the controller.
Set the Node Address
(ControlNet only)
Every ControlNet network requires at least one module that can store parameters
and configure the network with those parameters upon startup. The
CompactLogix controller is called a keeper because it keeps the network
configuration.
The CompactLogix controller can keep the network parameters at any legal node
address (01…99). Multiple devices on any one network can act as the network
keepers. Each device capable of being the network keeper acts to back up the
current keeper. This back-up function is automatic and requires no action on
your part.
Node address switches are set to the 99 position at shipment, as shown in the
figure.
Use these steps to set the node address.
Component Description
1769-BA battery
1747-KY controller key
If you want to Then use this component
Connect a device to the RS-232 port 1756-CP3 or 1747-CP3 serial cable
Add nonvolatile memory 1784-CF128 Industrial CompactFlash card
Connect to the EtherNet/IP port Standard Ethernet cable with RJ-45 connector
Connect to the ControlNet port • ControlNet taps for connections from controller channels A or B to the ControlNet network
• 1786-CP cable for connections from a programming terminal to the ControlNet network via the controller’s network
access port (NAP)