Allen-Bradley 1769 - Manually Change the Load Parameters

124 Rockwell Automation Publication 1769-UM011H-EN-P - April 2012
Chapter 9 Use a CompactFlash Card
Manually Change the Load Parameters
When you store a project to a CompactFlash card, you define:
• when the project is to load (On Power Up, On Corrupt Memory, User
Initiated).
• mode to which to set the controller (if the keyswitch is in REM and the
load mode is not User Initiated).
To assign a different project to load from the CompactFlash card, edit the
Load.xml file on the card.
1. To change the load parameters for a project, open the XML file with the
same name as the project. Use a text editor to open the file.
IMPORTANT
Be aware that when loading a different project, the firmware revisions
must be the same.
CompactFlash reader
projects and firmware
1.
2.
3.