47Publication IASIMP-QS001C-EN-P - October 2009 47
Chapter
3
Prepare the Distributed POINT I/O Hardware
In this chapter, you install the 1734 POINT I/O network adapter and the 1734 POINT I/O
modules.
Before You Begin
• Determine which of these network adapters to use:
– for an EtherNet/IP network (option 1), use the 1734-AENT adapter.
– for a ControlNet network (option 2), use the 1734-ACNR adapter.
– for a DeviceNet network (option 3), use the 1734-ADN adapter.
• Select the appropriate mounting base for I/O modules:
– if you use a 1734-IT2I module, then use the 1734-TBCJC.
– for all other I/O modules use the 1734-TB or 1734-TBS.
What You Need
• POINT I/O adapter: 1734-AENT, 1734-ACNR, and/or 1734-ADN
• POINT I/O mounting bases: 1734-TB or 1734-TBS, and 1734-TBCJC
• A digital-output POINT I/O module: The examples use a 1734-OB4E, however, other
POINT I/O modules can also be used, but are not required
• Power supply: 1794-PS3 or 1794-PS13
To Next Page
Loading...
