71Publication IASIMP-QS001C-EN-P - October 2009 71
Chapter
6
Prepare the PanelView Plus Terminal
In this chapter, you mount and wire power to a PanelView Plus terminal. You also configure
network communication and make network connections.
Before You Begin
Determine which network connection to use: EtherNet/IP, ControlNet, or serial.
Regardless of which CompactLogix controller you use, you need to connect to the PanelView
Plus terminal via an EtherNet/IP network for initial configuration, via a cross-over cable or
an Ethernet switch.
What You Need
• PanelView Plus terminal
• For a ControlNet network (option 2), use a PanelView Plus ControlNet interface
module
• One power supply, either a 1794-PS3 or a 2711P-RSACDIN
• Ethernet cable and switch or Ethernet cross-over cable
• For a serial connection (option 3), 2706-NC13 cable
To Next Page
Loading...
