Amada vm2500 - Supplying Cutting Fluid

II-10
SUPPLYING CUTTING FLUID
WARNING
O Use a water-soluble cutting fluid on this
machine.
Oil-based cutting fluids may emit smoke
or catch fire, depending on the condition
of their use. Never use oil-based cutting
fluids on this machine.
Pour the cutting fluid from
above its pan to a little
above the middle of the
sight gauge.
Tank capacity:
105 L {27.7 US gal}
SIGHT GAUGE
DRAIN PLUG
NOTICE
O If the cutting fluid pump motor is started without the cutting fluid tank filled to
the specified level, the cutting fluid pump may be damaged. Check that the
cutting fluid is at the proper level.