IV-29
ERROR LIST
W
hen an error is detected, the error message appears on the touch
screen.
To clear the error condition, do as described below.
Error message Error description Remedy Remarks
E001 EMERGENCY STOP EMERGENCY STOP
button is pressed.
Remove cause of
error, and pull out
EMERGENCY STOP
button.
E002 BLADE SLIPPED Saw blade slipped on
drive wheel.
Check saw blade and
cutting conditions.
E003 INVERTER ERROR Saw blade inverter is in
abnormal condition.
Contact AMADA.
Hydraulic
pump
motor
stops.
E004 COVER OPEN Wheel cover is open. Close wheel covers. Saw blade
stops.
E005 MOTOR OVERLOAD Motor is overloaded. Restore motor to
normal load condition,
and check motor.
E006 BACKGAUGE
OVERLOAD
Backgauge (option) is
overloaded.
Restore backgauge to
normal load condition,
and check backgauge.
E011 TABLE ADVANCE LIMIT Table reached forward
limit.
Contact AMADA.
E012 TABLE RECOIL LIMIT Table reached
backward limit.
Contact AMADA.
E013 TABLE SERVO DRIVER Table servo amplifier
detected error.
Turn off power and
back on. If error
recurs, contact
AMADA.
E014 BK.GAUGE SERVO
DRIV
Backgauge servo
amplifier detected
error.
Turn off power and
back on. If error
recurs, contact
AMADA.
Hydraulic
pump
motor
stops.
E015 COOLANT LEVEL Cutting fluid level is
low.
Add cutting fluid. Warning
E016 PLC BATTERY Sequencer memory
backup battery is
exhausted.
Contact AMADA.
E017 DEVIATION Runout detector
sensed saw blade
runout.
Reduce cutting rate or
change saw blade.
E018 BLD GUIDE POSITION Upper saw blade guide
became misaligned.
Check upper saw
blade guide for
abnormal condition.
(If abnormal condition
is found, contact
AMADA.)
Hydraulic
pump
motor
stops.
E019 BRUSH WORN Wire brush is worn. Replace wire brush
with new one.
Warning
To Next Page
Loading...
