Amada vm2500 - Operation During Cutting; Adjusting Cutting Rate

IV-17
Operation during cutting
A
DJUSTING CUTTING RATE
CNC INPUT display
1 Press the OVERRIDE
button to go to the
OVERRIDE display.
2 Press the CUT RATE
Ÿ or ź button to
adjust the cutting rate.
3 Each time the Ÿ or ź
button is pressed, the
cutting rate increases
or decreases by 1 %.
The settable range of
the override rate (%)
is 50 to 150%.
MANUAL INPUT display (cutting rate “cm
2
/min” input)
1 Press the R field to
open the numeric
keypad.
2 Enter the desired
value with the 0 to 9
and • keys to adjust
the cutting rate.
3 Press the ENT key.