Amada vm2500 - Setting Work Dimensions; Setting Running Speed of Saw Blade

IV-10
Setting work dimensions
S
et the work length and height as described below.
1 Press the PROGRAM button on the MENU display to go to the
PROGRAM display.
2 Press the AUTO CUT CONDIT button or MANUAL CUT CONDIT
button to go to the CNC INPUT display or MANUAL INPUT
display.
3 Press the DIMENT
button to go to the
DIMENT display.
4 Press the L field to
open the numeric
keypad.
5 Enter the work length,
and press the ENT
key.
6 Press the H field to
open the numeric
keypad.
1000
500
7 Enter the work height, and press the ENT key.
Setting running speed of saw blade
Set the saw blade running speed to suit the material type and size of
work to be cut as described below.
NOTICE
O If the running speed is improper, the cutting efficiency and economy both
suffer. Be sure to cut the work with a proper running speed. When using a
new saw blade, be sure to break it in as described in “Breaking in new saw
blade” later in this Part.
CNC INPUT display
On the CNC INPUT
display, the proper saw
blade running speed
(m/min or ft/min) is
automatically set and
shown in the V field when
the work length (L) and
height (H) are entered in
the L and H fields and the
standard and material type
of the work to be cut are
selected.