Amada vm2500 - Page 80

IV-12
N
OTE
O The cutting rate is given by
Cutting rate (cm
2
/min) =
(min) time Cutting
)(cm area Cutting
2
Cutting rate (cm
2
/min) for rectangle =
(min) time Cutting
h "u
or
Cutting rate (in.
2
/min) =
(min) time Cutting
)(in. area Cutting
2
Cutting rate (in.
2
/min) for rectangle =
(min) time Cutting
h "u
(height)
(length)
1 Press the R field to
open the numeric
keypad.
2 Enter the desired
value with the 0 to 9
and • keys to set the
cutting rate (cm
2
/min
or in
2
/min).
3 Press the ENT key.
When the parameter
No.2 “TABLE FEED”
on the
MAINTENANCE
display is set to “1:
mm/min”, enter the
table feed speed
(mm/min or in./min) in
the VT field.