114 Sequoia Series
4.26 Source Subsystem - Voltage
This subsystem programs the output voltage of the power source.
Subsystem Syntax
[SOURce:]
VOLTage
:ALC ON | OFF | REG Sets Automatic Level Control mode
[:LEVel]
[:IMMediate]
[:AMPLitude] <n> Sets the AC rms voltage amplitude
[:AC]
:DC
:OFFSet Set the DC offset value in AC+DC mode
:TRIGgered
[:AMPLitude] <n> Sets the transient voltage amplitude
:MODE <mode> Sets the voltage mode
(FIX|STEP|PULS|LIST)
:HIGH Sets the soft limits for maximum output
voltage to which the unit could be
programmed.
:LOW Sets the soft limits for minimum output
voltage to which the unit could be
programmed.
:PROTection
[:OVER]
[:LEVel] Sets the overvoltage protection threshold
:UNDER
[:LEVel] Sets the Undervoltage protection threshold
:RANGe
[:LEVel] <n> Sets the voltage range
:REFerence
[:MODE] Set the source of reference INT|EXT|RPV
:SENSe
[:SOURce] INTernal | EXTernal Sets voltage sense source
:SLEW
[:IMMediate] <n> | MAXimum Sets the voltage slew rate
:MODE <mode> Sets voltage slew mode
(FIX|STEP|PULS|LIST)
:TRIGgered
[:AMPLitude] <n> | MAXimum Sets the transient voltage slew rate
To Next Page
Loading...
Need help?
General
