Sequoia Series 151
5.13 *TRG
This command generates a trigger to any subsystem that has BUS selected as its source (for example,
TRIG:SOUR BUS).The command has the same effect as the Group Execute Trigger (<GET>)
command.
Command Syntax *TRG
Parameters None
Related Commands ABOR INIT
5.14 *WAI
This command instructs the power source not to process any further commands until all pending
measurement and calibration operations are completed. Pending operations are complete when all
commands sent before *WAI have been executed. This includes overlapped commands. Most
commands are sequential and are completed before the next command is executed. Overlapped
commands are executed in parallel with other commands. Commands that affect output voltage or
state, relays, and trigger actions are overlapped with subsequent commands sent to the power source.
The *WAI command prevents subsequent commands from being executed before any overlapped
commands have been completed.
The *WAI command may be used when performing measurement queries (MEAS or FETCh) to force
the power source to respond to the query before processing any subsequent command.
*WAI can be aborted by sending any other command after the *WAI command.
Command Syntax *WAI
Parameters None
Related Commands *OPC
To Next Page
Loading...
Need help?
General
