Sequoia Series 201
8.4 RTCA/DO-160D (-160)
The following are the remote commands set for DO-160D. ABORt command will terminate the test in
progress at any time.
Note that revisions E and F of the DO160 tests are implemented in the Sequoia Virtual Panels software
provided with the power source. These revisions cannot be run without the Sequoia Virtual Panels
software and don’t have an associated set of SCPI commands. The commands listed in this section
apply to the firmware-based revision D only. For information on revision E and F, refer to the Avionics
Software Manual, P/N 4994-972 provided on the AMETEK website www.programmablepower.com.
DO160
:NORMal
:VOLT_FREQ
:MINinum
:MAXimum
:VOLTage
UNBalance
:WAVeform :DISTortion
:VOLTage
:MODulation <numeric>
:INTerrupt <numeric>
:SURG
:DC
:UNDer
:FREQency
:MODulation <numeric>
:TRANSient
:VARiation
:EMERgency
:VOLT_FREQ
:MINimum
:MAXimum
:VOLTage
:UNBalance
:ABNormal stage
:VOLTage
:MINimum
:MAXimum
:UNDer
:OVER
:DC
:LOW
:FREQuency
:TRANsient
:CATegory
:STANdard
:GROup
To Next Page
Loading...
Need help?
General
