Ametek SEQUOIA Series Programming Manual

Sequoia Series 145
5.2 *ESE
This command programs the Standard Event Status Enable register bits. The programming
determines which events of the Standard Event Status Event register (see *ESR?) are allowed to set
the ESB (Event Summary Bit) of the Status Byte register. A "1" in the bit position enables the
corresponding event. All of the enabled events of the Standard Event Status Event Register are
logically ORed to cause the Event Summary Bit (ESB) of the Status Byte Register to be set. See
section 5.3 for descriptions of the Standard Event Status registers.
The query reads the Standard Event Status Enable register.
Bit Configuration of Standard Event Status Enable Register
Bit Position
7
6
5
4
3
2
1
0
Bit Name
PON
not
used
CME
EXE
DDE
QYE
not
used
OPC
Bit Weight
128
32
16
8
4
1
CME
Command error
DDE
Device-dependent error
EXE
Execution error
OPC
Operation complete
PON
Power-on
QYE
Query error
Command Syntax *ESE <NRf>
Parameters 0 - 255
Power-On Value 0 (see *PSC command)
Example *ESE 129
Query Syntax *ESE?
Returned Parameters <NR1>(Register value)
Related Commands *ESR? *STB?
5.3 *ESR?
This query reads the Standard Event Status Event register. Reading the register clears it. The bit
configuration of this register is the same as the Standard Event Status Enable register (see *ESE).
See chapter 7for a detailed explanation of this register.
Query Syntax *ESR?
Parameters None
Returned Parameters <NR1>(Register value)
Related Commands *CLS *ESE *ESE?
*OPC

Ametek SEQUOIA Series Specifications

General

Brand	Ametek
Model	SEQUOIA Series
Category	Portable Generator
Language	English