Ametek SEQUOIA Series - Source Subsystem - Program (Eload Mode)

84 Sequoia Series
Command Syntax [SOURce:]SYNChronize:FREQuency <NRf+>
Parameters 16 to 550 Hz
Unit Hz
Examples SYNC:FREQ 50
Query Syntax [SOURce:]SYNChronize:FREQuency?
Returned Parameters <NR2>
Related Commands SYNC:FREQ?MIN, SYNC:FREQ?MAX
[SOURce:]SYNChronize:PHASe
Phase Selectable
This command programs the sync phase level of the power source.
Command Syntax [SOURce:]SYNChronize:PHASe <NRf+>
Parameters -360 to +360
Unit deg
Examples SYNC:PHAS 240
Query Syntax [SOURce:]SYNChronize:PHAS?
Returned Parameters <NR2>
Related Commands SYNC:PHAS?MIN, SYNC:PHAS?MAX
[SOURce:]SYNChronize:VOLTage
Phase Selectable
This command programs the sync voltage level of the power source.
Command Syntax [SOURce:]SYNChronize:VOLTage <NRf+>
Parameters <NRf+>
Unit V
Examples SYNC:VOLT 250
Query Syntax [SOURce:]SYNChronize:VOLTage?
Returned Parameters <NR2>
Related Commands SYNC:VOLT?MIN, SYNC:VOLT?MAX
4.17 Source Subsystem – Program (eLoad Mode)
This subsystem programs the Operating Mode settings of the Sequoia Series power source.
Subsystem Syntax
[SOURce:]
PROGram
[:MODE]? Responds with current operating mode
:ELOAD
[:MODE] Sets the different SINK eLoad Operating
mode