Sequoia Series 125
4.28 System Commands
The system commands control the system-level functions of the power source.
Subsystem Syntax
SYSTem
:CHASis? Return number of chassis in a system
:CMODual
[:PRESent]? 1|2|3|4|all Return module presents in a chassis
:STATus? 1|2|3|4|all Return the modules status in a chassis
:TEMPerature
[:VALue]? Return the temperature value of the modules.
:FAULt? Return the temperature fault:status of the modules.
:QUERy
[:MODE] Select how the status are reported ASCii or BINary
:RESET Reset the user configuration to default state
:LED
[:STATE] Enable/Disable the Ambient LED Status feature
:DATE? Set and return date
:TIME Set and return time
:ERRor? Returns the error number and error string
:VERSion? Returns the SCPI version number
:LOCal Go to local mode (RS-232 only)
:REMote Go to remote mode (RS-232 only)
:CONFigure Set system configuration, password required
[:BYTE]
NOUT Set the number of output phases (one or three) if the
mode option is available
:ETIMe? Returns the elapse time
:COMMunicate
:GPIB
:ADDRess Set GPIB address
:LAN
:ADDRess Set LAN IP address
:APPLy Apply the change in setting
:CLASs Set LAN Host bits
:DEFault Set LAN to a default known setting
:DESCription Set user description
:DNSaddress Set LAN DNS address
:GWADdress Set LAN Gateway
:HOST Set the Host name.
:PASSword Set LAN password
:PORT Set LAN socket port address
:DHCP Enabel or disable DHCP
:MDNS Enable or disable MDNS
:SERial
:BAUD Set the baud rate
:PARity Set the parity type
:BITS Set number of bits
:SBITs Set number of stop bits
To Next Page
Loading...
Need help?
General
