Ametek SEQUOIA Series Programming Manual

76 Sequoia Series
REFerence[:MODE]
This command determines the source of its Current reference. if internal, the source uses its internal
current. If RPV, the input is a DC value correspond to the level of the internal oscillator signal.
Command Syntax [SOURce:]CURRent:REFerence[:MODE] <source>
Parameters INTernal|RPVoltage
Examples CURRent:REFererence INT
Query Syntax CURR:REF?
Returned Parameters <CRD>
Related Commands PONS:REF
CURRent:PHASE
This command is used to set the phase shift in eLoad Current Programming mode at the power-on.
Command Syntax [SOURce:]CURRent:PHASE
Parameters -90 to +90
Unit deg
Examples CURRent:PHASE 90
Query Syntax CURRent:PHASE?
Returned Parameters <NR2>
Related Commands CURR:PHASE?MIN, CURR:PHASE?MAX
CURRent:PF
This command is used to set the power factor in eLoad Current Programming mode at the power-on.
Command Syntax [SOURce:]CURRent:PF
Parameters -1 to +1
Examples CURRent:PF 1
Query Syntax CURRent:PF?
Returned Parameters <NR2>
Related Commands CURRent:PF?MIN, CURRent:PF?MAX
4.12 Source Subsystem – Power (eLoad Power Programming)
This subsystem programs the output power of the power source in eLoad Power Programming mode.
Subsystem Syntax
[SOURce:]
POWer
[:REAL] Sets the Active power required as a load for the UUT
:REACtive Sets the Reactive power required as a load for the
UUT
[SOURce:]POWer[:REAL]
Sets the Active power required as a load for the UUT

Ametek SEQUOIA Series Specifications

General

Brand	Ametek
Model	SEQUOIA Series
Category	Portable Generator
Language	English