184 Sequoia Series
8. Option Commands
8.1 Introduction
The Sequoia Series offers a number of options that are implemented in the power source controller.
If one or more of these options are installed, they may be used from both the front panel and the
interface. For front panel operation of any of these firmware options, consult the User Manual supplied
with the unit. For use in an automated test system, this chapter contains the command sub system
syntax for the available test options.
Specifically, the following firmware options are available at the time of this manual’s printing:
• IEC 61000-4-11, Option -411
• IEC 61000-4-13, Option -413
• MIL-STD 704E, Option -704
• RTCA/DO-160D, Option –160
• Airbus ABD0100.1.8 Option -ABD (Requires Sequoia GUI Software. No SCPI
commands available.)
• Airbus AMD24 Option -AMD (Requires Sequoia GUI Software. No SCPI
commands available.)
• Boeing B787-0147 Option –B787 (Requires Sequoia GUI Software. No SCPI
commands available.)
• WattHour Meter, Option -WHM
The power source will report all installed options, including any firmware options, when queried using
the SYST:CONF:BYTE? or *OPT? command. Additional firmware options may be added over time.
Consult the factory for additional information on firmware options not listed here but present on your
unit.
To Next Page
Loading...
