Sequoia Series 147
5.6 *OPT?
This query requests the power source to identify any options that are installed. Options are identified
by a string keyword or a number. A 0 anywhere in this list indicates that specific feature is not installed.
If a feature is installed or available, its corresponding keyword will be returned. Refer also to the
SYSTem:CONFigure[:BYTE] command. This command only has a query format as these settings
cannot be changed.
Query Syntax *OPT?
Returned Parameters <CRD>,[<CRD>]
The parameter list returned and their order in the sequence is shown in the table below.
This feature is always enabled on Sequoia Series
models.
Phase mode selection. Available only on Sequoia 2U,
3-Phase systems.
Available on Sequoia Series models with 3-Phase
controllers only.
Allows multiple controllers to be synced.
IEC61000-4-11 voltage dips and interruptions test
option. This option must be installed to support the
EOS1 or EOS3.
IEC61000-4-13 Interharmonics test option.
Supported only on i/iX Series with firmware CIC463-
5.
Airbus ABD0100.1.8 test option. Requires use of
Sequoia Virtual Windows software.
Limits interharmonics generator direct control output
to 500 Hz maximum.
Allows System field setting in Configuration menu to
be changed to support different configurations.
Boeing B787-0147 test option. Requires use of
Sequoia Virtual Windows software.
Airbus AMD24C test option. Requires use of Sequoia
Virtual Windows software.
Note: *OPT? response list will not have “ABD” field if firmware revision is less than 1.13
Note: *OPT? response list will not have “LF” field if firmware revision is less than 1.14.
To Next Page
Loading...
Need help?
General
