To Next Page

To Previous Page

Sequoia Series 77

Command Syntax [SOURce:]POWer[:REAL]

Parameters < NRf >

Example POW 20

Query Syntax [SOURce:]POWer[:REAL]?

Returned Parameters < NRf >

Related Commands POW:REAL?MIN, POW:REAL?MAX

[SOURce:]POWer:REACtive

Sets the Reactive power required as a load for the UUT

Command Syntax [SOURce:]POWer:REACtive

Parameters < NRf >

Example POW:REAC 10

Query Syntax [SOURce:]POWer:REACtive

Returned Parameters < NRf >

Related Commands POW:REAC?MIN, POW:REAC?MAX

4.13 Source Subsystem -Impedance (eLoad RLC Programming)

The IMPEDANCE command Programs the Resistance, Inductance and Capacitance required as a

load for the UUT

Subsystem Syntax

[SOURce:]

IMPedance < NRf > < NRf > < NRf > Sets the Resistance, Inductance and

Capacitance value

[SOURce:]IMPedance

The impedance command Programs the Resistance, Inductance and Capacitance required as a load

for the UUT.

Command Syntax [SOURce:] IMPedance

Parameters -1 to remove the connection, <NRf>

Example SOUR:IMP -1 10 13

Since -1 is programmed to Resistance, It is considered as Resistance

is not connected.

Query Syntax [SOURce:] IMPedance?

Returned Parameters < NRf >

Related Commands SOUR:IMP?MIN, SOUR:IMP?MAX

Ametek SEQUOIA Series Programming Manual

Other manuals for Ametek SEQUOIA Series