Ametek SEQUOIA Series Programming Manual

204 Sequoia Series
DO160:NORMal:FREQuency:MODulation
This command will cause output frequency modulation. The level of modulation is the function of the
rate of modulation. Refer to Figure 9-5 in the User Manual. The command parameter is the rate of
modulation in Hz.
Command Syntax DO160:NORMal:FREQuency:MODulation <NRf>
Parameters <frequency>
Examples DO160:NORM:FREQ:MOD 0.1
Query Syntax DO160:NORM:FREQ:MOD?
Returned Parameters <NR2>
DO160:NORMal:FREQuency:TRANsient
This command applies to Group 1 only for the European standard. Refer to Table 5 in the User
Manual.
Command Syntax DO160:NORMal:FREQuency:TRANsient
Parameters none
Examples DO160:NORM:FREQ:TRAN
Query Syntax none
Returned Parameters none
DO160:NORMal:FREQuency:VARiation
This command applies to Group 2 and 3 only for the European standard. Refer to Table 6 in the User
Manual.
Command Syntax DO160:NORMal:FREQuency:VARiation
Parameters none
Examples DO160:NORM:FREQ:VAR
Query Syntax none
Returned Parameters none
DO160:EMERgency:VOLT_FREQ:MINimum
This command will set the voltage and frequency to the minimum level for the emergency operation.
Command Syntax DO160:EMERgency l:VOLT_FREQ:MINimum
Parameters none
Examples DO160:EMER:VOLT_FREQ:MIN
Query Syntax none

Ametek SEQUOIA Series Specifications

General

Brand	Ametek
Model	SEQUOIA Series
Category	Portable Generator
Language	English